Test for structural drafting

Test for structural steel drafting

Question no. 1.
Draw free hand sketch for a 15.0m span truss showing top chord, bottom chord, and other members also make structural arrangement plans of the same. Take supports as concrete columns and draw end connection with anchor bolts. Spacing of truss is 6.0m c/c
Question no. 2.
Draw typical free hand sketch for gantry girder.
Question no. 3.
Make a sketch showing structural floor plan of a hall size 5.0mx12.0m with steel beams and concrete slab over permanent shuttering (Deck Sheet).
Question no. 4.
Arrange a outside Staircase to a building for access to floors at EL+ 5.5m, EL+ 8.0m, EL+ 15.0m and roof at EL+ 20.0m
Question no. 5.
Make typical detail of a grating 25mm thick used in floor of any size














Name Signature
………………………………………………………………………………………………………………………………………………………………….

Test for reinforced concrete drafting

Question no. 1.
Draw free hand sketch for 6.0m high RCC counter fort retaining wall
Question no. 2.
Draw free hand sketch for RCC water tank size 5.0mx4.0mx3.5m
Question no. 3.
Draw free hand sketch of a multi span continuous beam and a slab panel continuous in two directions.
Question no. 4.
Draw free hand sketch for foundation and column of following given data
Size of footing 2.3mx2.1mx400mm
Size of column 0.6mx0.4m
Footing steel 16? HYSD @150c/c bottom and 12?HYSD@250c/c at top
Column is reinforced with 4nos 25+4-20?HYSD bars
Column ties 10? HYSD @250c/c
Take depth of foundation as 3.0m from Ground level
Question no. 5.
Draw free hand sketch for machine foundation sized 6.0mx3.0mx5.0m depth below ground level is 2.5m. Make sample bar bending schedule for few bars as mentioned in questions above








Name Signature
……………………………………………………………………………………………………………………………………………………………..